Class1 Intelli Tank Quick Calibration Manuel d'utilisateur télécharger pdf

Intelli-Tank Display

Quick Manual

INSTALLATION

Ensure the unit is mounted with the TOP situated up before

applying the label to the display.

WIRING

The following details assume the 1-wire communication method

is used. For CAN communication information and set-up

please refer to the complete operation manual Class 1 p/n

114356.

Master – Only pins 1, 2, 6, 7, 8 are required for a system that

doesn’t use any remote units. Pin 4 must be used if remote

units are part of the system, and pin 3 should be used if the

display dimming feature is used.

Remote – Only pins 1, 2, 4 are required for a remote unit. Pin

3 should be used if the display dimming feature is used. Pin 4

of the Master and Remote units must be all tied together.

PRESSURE TRANSDUCER MOUNTING

Mount the transducer vertically to insure an accurate reading.

MAGNETIC SWITCH ACTIVATION

Magnetic switch locator.

The top two LEDs will light when the LEFT magnetic switch is

activated.

The bottom LED will light when the RIGHT magnetic switch is

activated.

1 POINT CALIBRATION

A magnet is required to activate the magnetic switches. Each of

the magnetic switch activations must occur within 2 seconds of

the last or the password will be reset.

1. Make certain the tank is FULL. Enter the password

RLLR LRRL. The unit will respond by flashing the top

LED twice. The unit will then start to normal operation

by displaying FULL (all LEDs on).

2 POINT CALIBRATION

A magnet is required to activate the magnetic switches. Each of

the magnetic switch activations must occur within 2 seconds of

the last or the password will be reset.

1. Enter the password RLLR LLRL. The unit will respond

by flashing the two center LEDs twice. The unit will then

begin cascading (drip) all four LEDs.

2. Make certain that the tank is EMPTY and then activate

the RIGHT switch to store that point. The unit will flash

the top LED and then turn on all four LEDs.

3. Fill the tank and then activate the RIGHT switch. The

unit will respond by flashing the top LED then lighting the

two center LEDs and then reverting to normal operation

by displaying FULL (all LEDs on).

CONFIGURING DIM SETTING

Use a magnet and enter the dim level configuration password

RLLR LLLR.

All LEDs will turn on at the last set dim level. Activate the RIGHT

switch to change the brightness. (Releasing the RIGHT switch

and then reactivating will change the direction of the brightness.)

Activate the LEFT switch when the desired level is attained.

OPERATION

During power up the display will individually cycle on each LED

starting with the bottom LED. The unit will then show current tank

level information.

DRIP = cascades from top (LED 4) to bottom (LED 1), pauses, and repeats.

For a detailed operation and troubleshooting

manual (p/n 114356) visit www.Class1.com

Manual PN 109395 Rev050906

Intelli-Tank Display 1
Quick Manual 1

Résumé du contenu

Page 1 - Quick Manual

Intelli-Tank Display Quick Manual INSTALLATION Ensure the unit is mounted with the TOP situated up before applying the label to the display. WIRIN

Commentaires sur ces manuels

Pas de commentaire

Class1 Intelli Tank Quick Calibration Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Class1 Intelli Tank Quick Calibration. Class1 Intelli Tank Quick Calibration User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Class1 Intelli Tank Quick Calibration